Arduino-ir-remote-json

Sketch arduino to send and receive IR signal with serial json communication.

This librairy was created to communicate in Json with NodeJs or other languages. Arduino-ir-remote-json is based on [IRremote] (https://github.com/z3t0/Arduino-IRremote) and [ArduinoJson] (https://github.com/bblanchon/ArduinoJson).

Hardware

Boards

Only tested on Arduino Uno.

IR Sensors

Only tested with Grove Sensors :

• [IR Emitter] (http://wiki.seeedstudio.com/wiki/Grove_-_Infrared_Emitter)
• [IR Receiver] (http://wiki.seeedstudio.com/wiki/Grove_-_Infrared_Receiver)

Installation

• Clone repository
• Install [IRremote] (https://github.com/z3t0/Arduino-IRremote) and [ArduinoJson] (https://github.com/bblanchon/ArduinoJson) with Arduino IDE library manager.
• Build and Upload on Board !

Configuration

You can configure IR receiver PIN and Serial Port. Go to Arduino-ir-remote-json.ino and change :

// PIN of ir receiver (IR emitter must be D3)
const int RECV_PIN = 2;

// Port for Serial
const int SERIAL_PORT = 9600;

JSON

{"type":3,"value":1270282502,"bits":32}

Type

Int	Device	Code	Test
-1	UNKNOW	Y	N
0	UNUSED	N	N
1	RC5	Y	N
2	RC6	Y	N
3	NEC	Y	Y
4	SONY	Y	Y
5	PANASONIC	Y	N
6	JVC	Y	N
7	SAMSUNG	Y	Y
8	WHYNTER	Y	N
9	AIWA_RC_T501	N	N
10	LG	Y	N
11	SANYO	N	N
12	MITSUBISHI	N	N
13	DISH	N	N
14	SHARP	N	N
15	DENON	N	N
16	PRONTO	N	N