Search results

V3 Right Angle on Ender 5 Max: 9mm offset in Y needed?

Status: Open.

#1309 In pellcorp/creality;

· atamgp opened on Apr 29, 2026

better --klipper-repo handling

Status: Open.

#1308 In pellcorp/creality;

· pellcorp opened on Apr 29, 2026

config overrides new section with a __DELETED__ value is added verbatim

Status: Open.

#1307 In pellcorp/creality;

· pellcorp opened on Apr 29, 2026

Ender 3 V3 support

Status: Open.

#1305 In pellcorp/creality;

· pellcorp opened on Apr 28, 2026

ender 3 v3 se has a beeper maybe

Status: Open.

#1290 In pellcorp/creality;

· pellcorp opened on Apr 24, 2026

Switch camera to mjpegstreamer (no -adaptive) and increase FPS to 15 for bltouch, microprobe and klicky

Status: Open.

#1286 In pellcorp/creality;

· pellcorp opened on Apr 24, 2026

Eddy-ng for kalico

Status: Open.

#1285 In pellcorp/creality;

· pellcorp opened on Apr 23, 2026

Create a hidden macro to force re-calibration of grumpyscreen

Status: Open.

#1253 In pellcorp/creality;

· pellcorp opened on Apr 14, 2026

Fix the debug_read error for cartographer, eddy, etc

Status: Open.

#1251 In pellcorp/creality;

· pellcorp opened on Apr 14, 2026

Consider getting rid of the ip address stuff to expose the camera directly, just do it all via nginx again

Status: Open.

#1250 In pellcorp/creality;

· pellcorp opened on Apr 14, 2026

reconnect crash handling for non critical mcu

Status: Open.

#1248 In pellcorp/creality;

· pellcorp opened on Apr 13, 2026

For setting serial - give consideration to retaining a previous serial rather than clearing it out

Status: Open.

#1217 In pellcorp/creality;

· pellcorp opened on Mar 29, 2026