Skip to content
This repository was archived by the owner on Dec 9, 2025. It is now read-only.

Using the HYT321 humidity sensor

Jump to bottom
ravinrabbid edited this page Mar 28, 2012 · 1 revision

Hardware

First modify your Hexabus board to use 3.3V, but completely remove R22 and R24 (see [here](Supply modification the Low Voltage board)). Now solder the HYT321's SDA pin to pin 20 (R24) on the ATmega and the SCL pin to pin 19 (R22). Connect the HYT321 to VCC and Ground and solder 4,7k pull-up resistors between SDA and VCC and SCL and VCC.

Software

In hexabus_config.h set I2C_ENABLE and HUMIDITY_ENABLE to 1.

If you also want to use the HYT321's temperature sensor, set TEMPERATURE_ENABLE to 1 and TEMPERATURE_SENSOR to 1.

Humidity can now be read via EID 5 and temperature via EID 3.

Clone this wiki locally