Issues

• The IR drops the job's tool shape, so verify --mesh needs --tool and can check only one cutter

  mountainarcwelding/campanion#146 · Filter by author DarkBiscuits opened on Nov 7, 2026

• audit rejects G53 in a mill program that read-back accepts ("unsupported G53")

  mountainarcwelding/campanion#145 · Filter by author DarkBiscuits opened on Nov 7, 2026

• A post can't declare G91.1: its own read-back rejects decimal G-codes ("G code is not an integer")

  mountainarcwelding/campanion#144 · Filter by author DarkBiscuits opened on Nov 7, 2026

• Tabs: none in run jobs; profile-document tabs rapid through stock and cut across corners

  mountainarcwelding/campanion#95 · Filter by author DarkBiscuits opened on Oct 26, 2026
  2

• A run job with two tools writes no tool change, and has no spindle speed

  mountainarcwelding/campanion#94 · Filter by author DarkBiscuits opened on Oct 26, 2026
  1

• Spindle stops and restarts around every depth pass

  mountainarcwelding/campanion#93 · Filter by author DarkBiscuits opened on Oct 26, 2026
  1

• Full circles off the whole-millimetre grid fail the post read-back ("point is off the arc")

  mountainarcwelding/campanion#92 · Filter by author DarkBiscuits opened on Oct 26, 2026
  1

• First ramp entry starts at the retract height, so it enters steeper than angle_deg

  mountainarcwelding/campanion#91 · Filter by author DarkBiscuits opened on Oct 26, 2026
  1

• Pocket rings dropped when the band is under twice the stepover, which leaves an uncut ring

  mountainarcwelding/campanion#90 · Filter by author DarkBiscuits opened on Oct 26, 2026
  1

• Hello from a hobbyist CNC router user: CAMpanion on 2.5D router parts, and a question about scope

  mountainarcwelding/campanion#88 · Filter by author DarkBiscuits opened on Oct 26, 2026
  1

• Pocket ignores entry and plunges straight in

  mountainarcwelding/campanion#89 · Filter by author DarkBiscuits opened on Oct 26, 2026
  1