This is a project to mount a little IP camera to my SnapMaker printer.
| Extender | Extender Lid | Seal(!) | Camera Arm | Camera Arm |
This should be printed with a somewhat large infill, since there is a lot of parts that requires a tight fit M3 screws. The config can be found under "Printing Config"
General config:
| Setting | Value |
|---|---|
| Layer Height | 0.2mm |
| Top Thickness | 0.8mm |
| Infil | 50%-80% |
!) i printed this part in rubber fillament, but it should also work without