-
Notifications
You must be signed in to change notification settings - Fork 1
Display
Pascal Roobrouck edited this page Jul 22, 2025
·
6 revisions
The display can show 3 different sensorChannels. These 3 'lines' are numbered 0 .. 2 from top to bottom. You can define which sensorDevice/sensorChannel is shown on which line in two ways:
- via the command-line interface
- via LoRaWAN Downlink
Note : when configuring the display to show a sensorChannel, make sure this sensorChannel is also configured as enabled (outputting measurements). Showing a sensorChannel which is disabled will show value 0.
This display always shows a status bar at the bottom with the following info:
- name of the device - see set name
- USB connection present or absent
- LoRaWAN network signal strenght
- battery charging level