-
Notifications
You must be signed in to change notification settings - Fork 0
Enter into RCM
Aleix Mariné Tena edited this page May 28, 2023
·
1 revision
Putting your switch in this mode will allow you to push payloads.
Steps:
- First make sure that your switch is completely shutdown. In stock or emuMMC mode you can do that by pressing down the power button for a few seconds, then a few options will apear and you have to select power off.
- Short the last two pins of the right joycon. It is so much easier with a jig. To use a jig introduce the jig until the end of the rail.
- While maintaining pressed the
+button, tap the power button. Your switch seemingly will not turn on. If it does turn on you did it wrong and need to start from the beginning. - You can now remove the RCM jig.
If the Switch seemingly does not turn on, your Switch entered into RCM mode and you can now push payloads.