Bench Testing?

[mprowe]

Hi,

Will I be able to check-out if my setup is working? If I get one of the three Supported Devices, can I test them at my workbench?
Or do these units "sleep" unless they are a pressurized and/or spinning?
I guess that the references I have seen saying that they only working above xMPH, is because of a centrifugal switch in the device?

Regards, Martin

[bkbilly]

Most of these devices keep on sending data even if there is no pressure but will send faster if they detect a pressure change.

[maroliar]

Hi! i bought this generic sensors https://www.amazon.ie/dp/B0DZWRJRBJ, and I confirm is working very well.

I'm running the Home Assistant in my car via Raspberry 4, and i had no problem at all.

The sensors was detected when i connected the battery in each one.

But, due to the quality of sensors, the updates is not happing every time, and the battery is fluctuating a lot.

[mprowe]

HI,
Thank you for the feedback. And yes, I am seeing sucess here to. Got mine from AliExpress.

I have set them up on my Motorhome with a Raspberry Pi and Teltonica cellular router. The outstanding issue that I havent tested yet, is the wheel ballance while driving? They are quite heavy. Have you any information on that?

Regards, M.