Did not hold dimensioning while printing/pi died

[Mubbler]

Two 5160 pro at 48v 2.8a running nema 23s.

When jogging the dimensioning held up nicely but while printing the dimensioning started to fail (ie needed 45mm but went 43mm). Eventually one of the motors started to visibly stall for brief periods of times during homing and some prints. The pi that came with the unit died shortly after this. Thinking the pi was the issue wondering or if I was pushing the board to hard.

[Trails5000]

you didnt mention what drivers you are using, the drivers are probably overheating

[Mubbler]

The btt 5160pros
https://www.amazon.com/gp/product/B0B8HZXWPP/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
They were not hot to the touch, and the pi no longer would show up in the device list when I checked for it.